Industrial aluminum manufacturers in the spraying process, still need to pay attention to many places, when handling should standardize processing, to make them more attractive and durable in use, so let's look at the details need to be aware of.

1. The problem of industrial aluminum spray paint room should be paid attention to:

Before the formal dust, you can run multiple tests of spray. At this point, you can look for the amount of powder, and the distribution uniformity of spray chamber at the ends of the powder. At this point, the powder from the claw 10 centimeters of less than at the end of the straight line movement, and the other part is the atomized powder form. Adsorption on contour surface of powder is, in fact, have effect of atomization powder. This is a gift? Have effect of atomized powder is used as the control claws and profile of the distance between the standard.

2. The choice of production and loading method of industrial aluminum profile fixing device:

The clamps at both ends should be able to withstand considerable pressure; the clamps used in the middle should minimize the contact points between the clamps and the outer surface of the profile during production and use, and should be placed vertically in the middle. The suspension rod is partially filled with powder, and the suspension position in the profile suspension should also follow the corresponding principle.

3. The pretreatment process is mainly used for degreasing and chromation, and the raw material consumption is relatively low. To increase production efficiency during the pre-treatment process, most aluminum profile manufacturers will use larger shelves to reduce drying energy consumption and install as many profiles as possible. However, for some softer contours, the cross bar must be placed in the middle of the contour in order to place the groove part as far as possible, which is also beneficial to the evaporation of moisture.

4. After the completion of the industrial aluminum profile, if there is still water remaining, and in order to avoid damaging the bismuth film on the surface of the profile, the profile is easily deformed when it is too high, so it should not be baked in the stove. At the time, we could use a dry method or use an air gun. In addition, during the drip-drying process, the contours must be kept at an appropriate tilt angle, but it is also easy to make certain contours slip. Therefore, it is necessary to use stainless steel wire mesh at one end of the rack as a precautionary measure.

In short, it is necessary to pay attention to these details during the spraying process of aluminum profile manufacturers, and it can extend the service life in the future.